Akai 726d tapedeck1/31/2024 This reduced the tape head count from 6 to 4, resulting in significant cost savings.įrom the links above, the last consumer reel to reel machine that Teac made was the X2000 in 1983. A number of decks provided a dual direction playback, while only recording in the forward direction. Teac made both single direction and auto reverse reel to reels, the auto reverse function using the standard foil strips at each end of the tape to trigger the reverse function. The dbx noise reduction system is based on a compression/expansion principle, and the tapes will sound awful if played back without the proper decoding. The only catch is that if you record a tape encoded with dbx, then you need to play it back with a dbx decoder. This is a big improvement over the 10db provided by a Dolby B noise reduction system. Generally speaking, with the exception of some of the early decks, Teacs have withstood the test of time, and have some common, easily repaired faults covered in the ‘pros and cons’ section below.Īs technology progressed, a number of the higher end Teac decks had built in dbx noise reduction, which improved the signal to noise ratio by about 30-35db. It’s a tough call on who sold the most consumer tape decks, Sony, Akai or Teac, as I see about equal amounts of them in for service and for sale. The capstan motor drive, by and large, was belt drive, again, with a few exceptions. Teac was an early adopter of the three motor transport design, meaning that the reel motors were direct drive (with a couple of exceptions), and the transports were therefore relatively simple and reliable. The earliest Teac deck I’ve seen is a 7” stereo tube Concertone made by Teac, and then when Teac became popular in the US in the late 1960s, I’ve serviced a ton of the 4010/6010/7010 models and beyond. (for the record, I have never seen a Teac TD-102) This writeup will concentrate on Teac, the consumer/stereo division, and Tascam, the recording studio/Pro audio division of reel to reels.Īnd a secondary write-up, with additional information: To start with, Wikipedia has a good summary of the origins of Teac and Tascam. I have this priced for FAR less than i nomally sell these for.Here’s the summary on Teac and Tascam reel to reel tape decks, based on servicing these decks for the last 40+ years. DO NOT expect any large price reductions. Makes a great transfer deck! Because of the record function issue mentioned the deck will be offered as is! Price is $399.99 or best offer. The sound when recording was working at 3 3/4 IPS is very clear and better and wider sounding than the Source recording from, depending on the type of tape used and even better at 7 1/2 IPS. Both channels work perfectly as well in play and source. After countless hours of unsuccessfully trying to figure out and repair the problem, I have decided to discontinue further efforts, cut my losses and sell this as a playback unit! Since these decks are mainly for playing tapes and transferring them to digital medium I'm not even going to pursue figuring out what the issue is. The record function does not work like it should. The pots and switches were sprayed and the metal parts were lubed as well. It has been fully tested and the heads were cleaned and demagnetized for the best sound ever. It is in good condition as shown albeit with some marks and wooden chips. For sale is a AKAI GX-267D 6 head 7 inch 4 track Auto Reverse Reel to Reel tape deck recorder.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |